- Specifications
- Photos
- Installations
Incline
![](https://sudenga.com/wp-content/uploads/2021/06/incline-400x303.png)
Standard Features
- 1,500 to 25,000 BPH
- 5° through 60° elbows
- Rack and pinion outlets with electric or manual opener
- Head Section: Flame cut sprockets on shafts up to 6-1/2″ (based on conveyor size); outboard mount pillow block bearings; UHMW shaft dust seals; shaft mount helical drive
- Tail Section: Flame cut sprockets on shafts up to 4-15/16″ (based on conveyor size); threaded rods provide chain tension
Capacities & Dimensions
Choose a conveyor and chain speed based on capacity required. Choosing a larger conveyor running at slower speeds requires less maintenance than smaller conveyors running at faster speeds. Also, capacities can be raised later, if needed. NOTE: The angle of incline does not significantly alter capacities due to paddle design. Use the capacity figures, below, for all inclines.
Figuring Horsepower
![](https://sudenga.com/wp-content/uploads/2022/10/installation-leg-fischer-159-400x225.jpg)
Farm Site in NW Iowa
Check out this northwest Iowa farm site featuring a Medium 30 Bucket Elevator, an Incline Chain Conveyor, and a Reclaim Conveyor.
Read More