Horizontal Drag Chain Conveyors

• 3,500 to 30,000 BPH unloading rates
• Runs to 200 feet
• Rack and pinion outlets with electric or manual opener
• Head section: Flame cut sprockets on shafts up to 6-1/2″ (based on conveyor size); outboard mount pillow block bearings; UHMW shaft dust seals; shaft mount helical drive
• Tail section: Flame cut sprockets on shafts up to 4-15/16″ (based on conveyor size); threaded rods provide chain tension
• Nylon return rollers

• 5° and 10° elbows provide discharge clearance
• Abrasion resistant side and bottom liners
• D81XHH chain in lieu of D81X chain (where applicable)
• Nylon paddles
• Double flight chain and paddles
• Recycle cups
• Slack chain detectors and plug switches
• Return rail packages

Choose a conveyor and chain speed based on capacity required. NOTE: Choosing a larger conveyor running at slower speeds requires less maintenance than smaller conveyors running at faster speeds. Also, with a larger conveyor, capacities can be raised later, in some applications.

Standard Inlet: Inlets sit on the intermediate section lid. The intake opening is placed away from the tail.

Metering Plate: Mount below hopper tank inlets to meter product flow into conveyor.

Bypass Inlets: Bypass inlets direct incoming grain around the upper return chain. Internal gates can be adjusted to fine tune capacities.

Plain Outlet: May be used under manual and electric outlet gates.

Leg Outlet: Leg outlets are used where an offset outlet is required.

Inquire about additional options and accessories.